I cannot see defined sensor using topographic correction

[Erica Matta]

Hello,

I have the following problem: I cannot select a user defined sensor when I try to run the "quick topographic (no atm.) correction" (in the relative GUI panel), 
while I can see my defined sensor if I compile the atmospheric correction GUI panel.

Thank for your help

[reseadmin]

Most probably the Atmospheric Look-Up-Table for this specific sensor is missing; please make sure to download the atmospheric database through the Help Menu and run the Sensor:RESLUT function to resample it to the required sensor.

[Erica Matta]

Most probably the Atmospheric Look-Up-Table for this specific sensor is missing; please make sure to download the atmospheric database through the Help Menu and run the Sensor:RESLUT function to resample it to the required sensor.

Thank you for your answer.

I run the RESLUT function again (I already did it when I defined my sensor) and the problem persists.
If I well did it I have to find a folder inside the "\\atcor_23\atm_lib" folder, with the name of my sensor, right? And this folder contains a series of *.atm files such as "h99000_wv04_dese.atm" and so on.

I'm asking to myself: is this series of .atm files useful for the QUICK TOPOGRAPHIC (no Atm.) CORRECTION function? How?

Thank you for your reply